One, storage needs to pay attention to:
1. The steel with serious rust should not be kept for a long time after rust removal and should be used as soon as possible. Materials should be careful to prevent rain or mixed with impurities before storage.
2. The material that has touched water should be removed in time by different methods according to its nature, such as the available steel wire brush with high hardness, and the cotton cloth with low hardness.
3. Check the material regularly after storage. If there is rust, remove the rust layer.
4. It is not necessary to coat the surface of general steel after cleaning, but for high quality steel, alloy thin steel plate, alloy steel pipe, etc., after rust removal.
Two, installation is matters needing attention:
1. Use the environment
In order to improve the service life of Angle steel production line equipment, Simatt generally requires manufacturers to avoid direct sunlight and other thermal radiation, to avoid too wet, corrosive gas or too much dust. Corrosive gas makes electronic components corroded and easy to deteriorate, resulting in bad contact or short circuit between components, affecting the normal operation of equipment. Precision Angle steel production line equipment should be far away from large vibration equipment, such as punch, forging equipment, etc..
2. Power supply requirements
In order to avoid the influence of large fluctuation range of power supply (more than ±10%) and possible instantaneous interference signal, the equipment of Angle steel production line generally adopts special line power supply or additional voltage regulator, which can reduce the influence of power supply quality and electrical interference.
3. Operating procedures
Operation rules are important measures to ensure the safe and stable operation of CNC machine tools. Operators must operate according to the operation rules. When the machine fails, the operator should pay attention to keep the site well, and truthfully reflect the situation before and after the failure to the maintenance personnel, so as to facilitate the analysis, diagnosis of the cause of the failure and timely elimination.
In addition, Angle steel production line equipment should not be sealed for a long time. After purchase, it should be fully used, especially in the first year of use, so that the weak links prone to failure are exposed as soon as possible, and can be eliminated in the warranty period. In the absence of processing task, Angle steel production line equipment is regularly electricity, electricity 1-2 times a week, empty operation and 1 hour at a time, taking advantage of the machine itself calorific value to reduce the humidity inside the machine, make the electronic components not be affected with damp be affected with damp.
Post time: May-11-2022